C5ALIVE Forum
C5Alive General Category => Welcome To The Forum => Topic started by: malfunction on 14, April, 2013 - 03:29:52
-
Hi , My name is Malcolm and I am a C5aholic.
The last (and first time since I was a kid) time I rode a C5 was yesterday.
I have been looking of a C5 for a while, and met a guy with some to restore. One of which will be mine.
My progress restoring the C5s is documented here. http://malfunction.faed.name/search/label/C5 (http://malfunction.faed.name/search/label/C5)
I am almost done identifying what parts I will need and will need to go shopping. ;)
I look forward to 'meeting' you here..
Malcolm.
-
Welcome to the forum ;) ;) ;) ;)
-
Welcome Malcolm any help you want just ask ....bye Chas
-
Hi Malcolm
I see you are from Australia - welcome! ;D
-
Hello Malcolm
Welcome to the forum and good luck with your C5's.
Dave
-
Hello and welcome to the C5 Alive forum, Please post us some sun shine this way :)
Retro Andy.
-
Welcome to the forum - enjoy :)
-
glad to have you aboard mate 8)
-
Not sure of the best forum for tech notes, but here is some data on the motor and gearbox components.
C5 drive components
Planetary gearbox output drive pulley:
- Diameter ~31mm
- 21 tooth
Axle Drive pulley:
- Diameter ~107mm
- 68 tooth
- One Way Bearing INA HFL 2026
Drive Belt:
- Length = 400mm
- Width = 18mm
- Teeth = 80 tooth
- 5mm Pitch
- Megadyne Isoran 400 RPP5
- Local .au equivalent - 400-T5 80 400.0 from http://www.naismith.com.au/catalogues/pulleys/metric.pdf
Final ratio = 21/68 = .308 or a 3.23 reduction.
Replacement Aluminium Pulleys from Naismith in Sydney:
- Large = 60 60-T5-16
- Small = 18 18-T5-16F for similar final drive ratio.
Could use 25mm wide pulleys to allow for machining.
Motor Bearing - Both Ends: GMN 6201 - data http://www.gmnbt.com/deep-groove-bearings-selection-guide.htm
Planetary support bearing x2 (on drive end of motor shaft) GMN 607
Large output shaft bearing 61808
3 x Gearbox planet carrier shafts ~ 8mm