C5ALIVE Forum
C5Alive General Category => C5 Chatroom => Topic started by: kamilb1998 on 02, May, 2012 - 17:36:36
-
With the new 18mm drive belt & cable tie round the wall that holds the gearbox up that Karl fitted I now get no belt slip when pulling away just using the motor. ;D If I do only use the motor to pull away, will it cause any premature wear to the gearbox or the big drive cog?
-
Hi there Kamilb not sure what you mean but you should never pull away with just using the motor unless you are going down hill . But I would never pull away unless I was peddling ...Regarding wear you will wear out the small cog on the gearbox first ...And that could cost you a lot of money to replace the .....
bye Chas
-
Could damage the inner gears I should imagine, but more likely the motor commutator as its close to stall . would definitely with my weight :-\ :-\
-
Chas, what I mean is that I get no belt slip if I use the motor from a standstill. And I was just curious as to whether it could cause any damage to anything even if I don't get any belt slip.
-
With the new 18mm belt Chas fitted.....
ahem ??
..not forgetting the large cable tie I fitted at the same time as fitting the drive belt ?
-
With the new 18mm belt Chas fitted.....
ahem ??
Were you the one who fitted it? :-[ :-[
-
..certainly was :-*
-
..certainly was :-*
:-[ :-[ Sorry. Edited the original post now.