Hi all
Fitted up my new drive shaft, wheel and bearings and just have a question about the hub cap.
I have bolted on the wheel and screwed on the bearing bit, so the wheel spins nicely. Now, i think im meant to put on the big hub cap, then the large flat washer then the locking nut.
But when i do this and tighten the locknut, it tightens the inner bearing bit and starts to lockup the wheel.I see theres a flat spanner bit on this 'bearing bit' onbviously to hold it in place when you do up the locking nut.
the cap is also loose and wiggles a bit.
Whats the order of putting it back together? am i missing something, Many thanks, poze