C5Alive General Category > C5 Pimping !

Take one angle grinder.....

(1/5) > >>

Karl:
Oh yes, take a "scrap" Sinclair C5 and remove the bodyshell..



Then find your angle grinder .. ???



I think you can see where this is going... :o







Phase One is now complete  8)

More to follow in about a week or so... :P :-X

radiomarty:
Are you OK Karl ?????????

Karl:

--- Quote from: radiomarty on  05, September, 2009  - 21:32:58 ---Are you OK Karl ?????????

--- End quote ---

Never better mate  ;D

I know it looks bad at the moment , but it's something I've planned for quite a while now, developed from a chat with C5Martin a while back. Progressing nicely  :)

With luck, this project will be ready for Brooklands on the 20th - if not then it will be shown at the 25th Anniversary event January next year.

And in case anyone was wondering , the bodyshell had a huge vertical split in one side and a very rusty chassis complete with a DIY wiring job.

I wouldn't take an angle grinder to a salvageable C5, honest !!

Retro Andy:
You look like Jack Nicholson in the "Shining" with that grin, Did you say :- Hello C5 shell, daddy's home ?

P.S. Not being rude Karl, but have you put a couple of pounds on and need to make the seat a bit widder ?  ;D

P.P.S. Only joking mate  ;)

Retro Andy.

radiomarty:
Yes I agree a very worrying grin !!!!!!
Looking forward to seeing the finished project.

Navigation

[0] Message Index

[#] Next page